Container forging is the article which is used to make the required shape and appropriate compression force through plastic deformation. The container forging is mainly realized through the use of hammer or pressure.
The container forging has changed the physical properties of the metal to a certain extent. In the practical use of parts, a correct design can make the particles flow in the direction of the main pressure. At the time of production, each piece needs to be consistent, without any porosity and inclusions. The strength and weight ratio has a high ratio.
The introduction of the container forgings
The container forging has a extensile length, a collapsible length, a extensile cross section, a changeable length, and a changeable cross section. The types of forgings are: free forging、 hand forging, hot forging、 precision forging, top forging, rolling forging and die forging.
The induction heating of the container forgings
It is supported on a dedicated rotary table when used. The forging is mainly based on its own great trust on the wheel rotation, and the internal and external circle itself can be freely retractable, the sensor fixed position can be separated from the ring heating surface can be telescopic. The expansion of the sensor is mainly in the ring after the expansion of the shrinkage and changes the sensor and heating surface clearance.
The intermediate and double frequency induction heating of the product, with a circular sensor set on the body, from the bottom to the continuous edge heating water quenching, such as cold roll, piston, cement mill wheel, etc. The special long forgings, due to the limited length, can not be vertically lifted on the quenching machine, only horizontally lied, with special sensors and transformers, crawling on the shaft or sliding along the guide rail.
The change of the clearance will affect the heating rate and the heating temperature. In order to maintain the stability of the sensor combined with the heating surface, the sensor will also move synchronously when the coil is heated. Thus, when heating the inner and outer ring surfaces of a large circle, the sensor and the circle surface always have a machine position and can push the sensor forward or backward with the loop heating surface.
Wuxi Jiayi Forging CO.,LTD